Breaking In A New Machine - Toro Workman GTX Operator's Manual

Using the Battery System
When your batteries are fully charged, the tenth
bar (far right) illuminates on the battery-discharge
indicator (Figure 11).
1. Battery-discharge
indicator
As you use the machine, the bars disappear as the
electrical capacity of the batteries is used.
When only the second bar from the left remains on
the battery-discharge indicator, it is a good time to
charge (Figure 12).
Figure 12
1. The 2 left bars alternately blink until you charge the
batteries.
Figure 11
2. Charge-indicator bars
If you continue to use the machine with only 2 bars
remaining, bars 1 and 2 alternately flash.
Important:
When only the second bar from the
left remains on the battery-discharge indicator,
the machine may enter a reduced-speed mode;
this mode aids in protecting the batteries, but
prolonged operation in this mode can damage
the batteries and/or the machine. Avoid draining
your batteries down to the second bar from the
left to prevent this issue. Charge the batteries
immediately.
If the batteries become fully discharged, the
machine shuts down. Do not allow the batteries to
become fully discharged.
Important:
To obtain maximum battery life,
always charge the batteries before the charge
reaches the second bar from the left on the
screen. Regularly depleting the batteries to lower
than the second bar from the left reduces the life
of the batteries.
g192308

Breaking in a New Machine

Service Interval: After the first 100 hours—Perform
Perform the breaking in a new machine guidelines
to provide proper performance and long life for the
machine.
•
Check the brake fluid and the water level in the
batteries regularly.
•
Avoid hard braking situations for the first several
hours of new machine break-in operation. New
brake linings may not be at optimum performance
until several hours of use has caused the brakes
to become burnished (broken-in); refer to
Burnishing the Brakes (page
•
Refer to Maintenance (page 24)
low-hour checks.
•
Check the front suspension positioning and adjust
it, if necessary; refer to
Alignment (page
g192309
16
the breaking in a new machine
guidelines.
9).
for any special,
Adjusting the Front Wheel
40).
3