Mitsubishi Electric 800 Series Instruction Manual page 124

 Speed limit by parameters (Pr.807 = "1")
• Following the polarity change in the torque command, the polarity of the speed limit value changes. This prevents the
speed from increasing in the torque polarity direction. (When the torque command value is 0, the polarity of the speed limit
value is positive.)
• When Pr.807 Speed limit selection = "0", the setting during speed control is applied for the speed limit. When Pr.807
Speed limit selection = "1", Pr.808 Speed limit is applied for the speed limit.
• When the load has reversed the rotation opposite to the torque polarity, the setting of Pr.809 Reverse-side speed limit
is applied for the speed limit. (The speed limit value and reverse-side speed limit value are limited at Pr.1 Maximum
frequency.)
Reverse-side
speed limit value
-Pr.809
-Speed limit value
Rotation speed
Pr.7
Speed limit value
-Pr.809
Reverse-side
speed limit value
OFF
Start signal
When the torque command value is positive
NOTE
• During the speed limit operation, "SL" is displayed on the operation panel and the OL signal is output.
• For the OL signal, set "3" (positive logic) or "103" (negative logic) in one of Pr.190 to Pr.196 (Output terminal function
selection) to assign the function to the output terminal. Changing the terminal assignment using Pr.190 to Pr.196 may affect
the other functions. Set parameters after confirming the function of each terminal.
Parameters referred to
Pr.1 Maximum frequency, Pr.2 Minimum
Pr.4 to Pr.6, Pr.24 to Pr.27, Pr.232 to Pr.239 (multi-speed
Pr.7 Acceleration time, Pr.8 Deceleration
Pr.13 Starting frequencypage 175
Pr.190 to Pr.196 (Output terminal function
Torque
command
value Speed limit value
Range where torque
control is available
Rotation speed
Reverse-side
speed limit value
Pr.809
Range where torque
control is available
Pr.8
Time
ON
frequencypage 219
operation)page 202
timepage 164
selection)page 258
Range where torque
Rotation speed
control is available
Pr.809
Reverse-side
speed limit value
Speed limit value
Pr.7
OFF ON
Start signal
When the torque command value is negative
1
2
3
4
5
6
7
8
9
Time
Pr.8
10
123
6. Torque Control
6.4 Speed limit