Installing The Discharge Chute; Filling The Engine With Oil - Toro Power Clear 621QZE Operator's Manual

2

Installing the Discharge Chute

Parts needed for this procedure:
3 Screws
1 Chute assembly
Procedure
Install the discharge chute as shown (Figure 7).
1. Discharge chute
Note: For easier installation, use a small ratchet wrench
to tighten the screws.
Important: Do not overtighten the screws;
otherwise you may damage the discharge chute and
prevent it from turning freely.
3

Filling the Engine with Oil

No Parts Required
Procedure
Your machine does not come with oil in the engine, but
it does come with a bottle of oil.
Important: Before starting the engine, fill the
engine with oil.
Figure 7
2. Screw (3)
Note: The bottle of oil may contain an ounce or two
more than the engine requires. Do not overfill the
engine.
Max fill: 20 oz. (0.6 l), type: automotive detergent oil
with an API service classification of SJ, SL, or higher.
Use Figure 8 below to select the best oil viscosity for the
outdoor temperature range expected:
1. Move the machine to a level surface.
2. Clean around the oil fill cap (Figure 9).
1. Oil fill cap
3. Unscrew the oil fill cap and remove it.
4. With the machine in the operating position, carefully
pour oil into the crankcase. Allow a minute for the
oil to settle and add enough to bring it to the point
of overflow. There should be very little, if any, oil
left in the bottle.
5. Screw the oil fill cap into the oil fill hole and tighten
it securely.
6
Figure 8
Figure 9