Locating the Tie-Down
Points
There are tie downs located at the front and rear sides
of the machine
(Figure
Note:
Use properly-rated DOT-approved straps in 4
corners to tie down the machine.
•
2 on the front of the operator's platform
•
Rear tire
Figure 29
1. Tie-down point
29).
Pushing or Towing the
Machine
In an emergency, you can move the machine a very
short distance by actuating the bypass valve in the
hydraulic pump and pushing or towing the machine.
Important:
Do not push or tow the machine
faster than 3 to 4.8 km/h (2 to 3 mph). If you push
or tow at a faster speed, internal transmission
damage may occur. If you must move the machine
a considerable distance, transport it on a truck
or trailer.
Important:
The bypass valve must be open
whenever you push or tow the machine. Close
the valve once you have pushed or towed the
machine to the desired location.
1.
Locate the bypass valve on the pump
30) and loosen it by rotating 90° (1/4 of a turn).
g192121
g192122
1. Bypass valve
2.
Push or tow the machine.
3.
Finish pushing or towing the machine and close
the bypass valve by rotating it 90° (1/4 turn).
Important:
closed before you start the engine. Running
the engine with an open bypass valve causes
the transmission to overheat.
33
Figure 30
Ensure that the bypass valve is
(Figure
g031610