Product Overview; Controls - Toro Groundsmaster 3505-D Operator's Manual

Product Overview

Controls

Figure 22
1. Tilt-steering lever
2. Reverse traction pedal
3. Forward traction pedal
Figure 23
1. Parking brake
2. Cutting-unit-shift lever
3. Cutting-unit-drive switch
4. Alternator light
5. Oil-pressure light
6. Temperature light
4. Mow/transport slide
5. Indicator slot
7. Glow-plug-indicator light
8. Hour meter
9. Throttle
10. Ignition switch
11. Lift lever lock
Traction Pedals
Press the forward traction pedal to move forward.
Press reverse traction pedal to move backward or to
assist in stopping when moving forward
Note:
Allow the pedal to move or move it to the
position to stop the machine.
NEUTRAL
Tilt-Steering Lever
Pull the tilt-steering lever back to tilt the steering wheel
to the desired position, then push the lever forward to
tighten (Figure
Parking Brake
Whenever you shut off the engine, engage the parking
brake to prevent accidental movement of the machine.
To engage the parking brake, pull up on the lever
(Figure 23).
Note:
The engine shuts off when you press the
g196137
traction pedal with the parking brake engaged.
Key Switch
The key switch is used to start, stop, and preheat
the engine. The ignition switch has 3 positions:
O , O /P
FF N REHEAT
O /P position until the glow-plug-indicator light
N REHEAT
goes out (approximately 7 seconds); then rotate the
key to the S
TART
Release the key when the engine starts
To shut off the engine, rotate the key to the O
position.
Note:
Remove the key from the switch to prevent
accidental starting.
Seat-Adjustment Lever
Move the seat-adjustment lever on the side of the
seat outward, slide the seat to the desired position,
and release the lever to lock the seat into position
(Figure 24).
g031597
Fuel Gauge
The fuel gauge registers the amount of fuel in the tank
(Figure 24).
19
22).
, and S . Rotate the key to the
TART
position to engage the starter motor.
(Figure 22).
(Figure 23).
FF