Locating The Fuses; Drive System Maintenance; Adjusting The Traction-Pedal Angle; Checking The Planetary-Gear-Drive Oil - Toro 30605 Operator's Manual

Locating the Fuses

The traction-unit fuses are located under the power-center
cover (Figure 54, Figure 55, and
Remove the 2 screws securing the power-center cover to the
frame and remove the cover
Figure 54
1. Power-center cover
Figure 55
1. Fuses
Figure 56
Figure 56).
(Figure 54).
2. Screws
Drive System
Maintenance
Adjusting the Traction-Pedal
Angle
1. Loosen the 2 nuts and bolts securing the left side of the
traction pedal to the bracket
1. Traction pedal
2. Pivot the pedal to the desired operating angle and
tighten the nuts
Checking the
Planetary-Gear-Drive Oil
Service Interval: Every 400 hours (check if you notice
external leakage).
Every 400 hours
Use high quality SAE 85W-140 gear lube as a replacement.
1. With machine on level surface, position the wheel so 1
check plug is at the 12 o'clock position and the other
is at 3 o'clock position
1. Check/drain plug (2)
2. Remove the plug at the 3 o'clock position
45
(Figure 57).
Figure 57
2. Mounting nuts and bolts
(Figure 57)˙.
(Figure 58).
g019500
Figure 58
(Figure 58).