Table of Contents
Advertisement
jelly, or light grease to prevent corrosion. Slide the
rubber boot over the positive terminal.
4. Close the battery cover.
Fuses
The traction unit fuses
(Figure 54
under the power center cover.
Remove the two Allen head screws securing the power center
cover to the frame and remove the cover
Figure 54
1. Power center cover
Figure 55
1. Fuses
Figure 56
thru
Figure
56) are located
(Figure
54).
2. Allen head screws (2)
Drive System
Maintenance
Adjusting the Traction Pedal
Angle
The traction pedal operating angle can be adjusted for
operator comfort.
1. Loosen the two nuts and bolts securing the left side of
the traction pedal to the bracket
1. Traction pedal
2. Pivot the pedal to the desired operating angle and
tighten the nuts
Changing the Planetary Gear
Drive Oil
Service Interval: After the first 200 hours
Every 800 hours (Or yearly, whichever comes first)
Change the oil initially after first 200 hours of operation.
Thereafter change the oil every 800 hours, or yearly, whichever
occurs first. Use a high quality SAE 85W-140 gear lube.
1. With the machine on a level surface, position a wheel
so that one of the check plugs is at the lowest (6
o'clock) position
44
(Figure
57).
Figure 57
2. Mounting nuts and bolts
(2)
(Figure
57)˙.
(Figure
58).
Advertisement
Table of Contents
