Checking The Rear-Axle-Gearbox Lubricant; Changing The Rear-Axle Lubricant - Toro 30605 Operator's Manual

Checking the
Rear-Axle-Gearbox Lubricant
Service Interval: Every 400 hours
The gearbox is filled with SAE 85W-140 gear lube. The
capacity is 0.5 L (16 oz). Visually inspect for leaks daily.
1. Position the machine on a level surface.
2. Remove the check/fill plug from the left side of the
gearbox and ensure that lubricant is up to the bottom
of the hole (Figure
Note: If the level is low, add enough lubricant to bring
the level up to the bottom of the hole.
1. Gearbox
Changing the Rear-Axle
Lubricant
Service Interval: After the first 200 hours
Every 800 hours
Change the lubricant initially after the first 200 hours of
operation and every 800 hours of operation thereafter.
1. Position the machine on a level surface.
2. Clean the area around the 3 drain plugs; 1 on each end
and 1 in the center
3. Remove the check plugs to ease in the draining of the
oil.
4. Remove the drain plugs and allow the oil to drain into
the pans.
62).
Figure 62
2. Check/fill plug
(Figure 63).
1. Drain-plug location
5. Clean the area around the drain plug at the bottom of
the gearbox (Figure
6. Remove the drain plug from the gearbox and allow the
oil to drain into a pan.
Note: Remove the fill plug to ease in the draining of
the oil.
1. Drain plug
7. Add enough oil to bring the level up to the bottom
of the check plug holes; refer to
Rear-Axle Lubricant (page
Rear-Axle-Gearbox Lubricant (page
8. Install the plugs.
47
Figure 63
64).
Figure 64
Changing the
47), and Checking the
47).