Toro 30605 Operator's Manual page 25

5. Remove the hairpin cotter and clevis pins from the
caster-pivot arms (Figure
6. Rotate the tension rod to raise or lower the pivot
arm until the holes are aligned with the selected
height-of-cut bracket holes in the mower-deck frame
(Figure 20 and Figure
Figure 20
1. Caster-pivot arm
2. Axle-mounting holes
Figure 21
7. Insert the clevis pins and install the hairpin cotters.
8. Rotate the tension rod counterclockwise (finger tight)
to put tension on adjustment.
9. Remove the hairpin cotters and clevis pins securing the
damper links to the mower-deck brackets
Important: Do not adjust the damper-link length.
The length between the hole centers should be
13.7 cm (5-3/8 inches).
20).
21).
3. Clevis pin and hairpin
cotter
4. Tension rod
(Figure
1. Damper link
10. Align the damper-link holes with the selected
height-of-cut bracket holes in the mower-deck frame,
insert the clevis pins, and install the hairpin cotters
(Figure 23).
22).
25
Figure 22
Figure 23