Toro 30605 Operator's Manual page 14

Parking-Brake Latch
A knob on the left side of the console actuates the
parking-brake lock (Figure
To engage the parking brake, connect the pedals with the
locking latch, push down on both pedals, and pull the
parking-brake latch out. To release the parking brake, press
both pedals until the parking-brake latch retracts.
Hazard-Light Switch (Optional)
Press the hazard-light switch to activate the hazard lights
(Figure 3).
Turn-Signal Switch (Optional)
Press the left side of the turn-signal switch to activate the
left-turn signal and the right side of the switch to activate the
right-turn signal (Figure 3).
Key Switch
The key switch (Figure 4) has 3 positions: O
O /P , and S
N REHEAT TART
3
2
4
5
6
7
1. Lift switches
2. PTO switch
3. Key switch
4. InfoCenter
Engine-Speed Switch
The engine-speed switch has 2 modes to change the engine
speed (Figure 4).
By momentarily tapping the switch, you can increase or
decrease the engine speed in 100-rpm increments. When you
hold the switch down, the engine automatically moves to
H or L , depending on which switch you press.
IGH OW IDLE
3).
,
FF
.
1
Figure 4
5. High-Low speed control
6. Engine-speed switch
7. Light switch (optional)
PTO Switch
The PTO switch has 2 positions: O
Pull the PTO button out to engage the mower-deck blades.
Push the button in to disengage the mower-deck blades
(Figure 4).
High-Low Speed-Control Switch
The High-Low speed-control switch allows the speed range
to increase for transport of the machine
Mower decks do not operate in high range. To switch between
the H and L
IGH
disengage the cruise control, move the traction pedal in the
N position, and move the machine at a slow speed.
EUTRAL
Lift Switches
The lift switches raise and lower the mower decks
4). Press the switches forward to lower the mower decks
and rearward to raise the mower decks. When starting the
machine, with the mower decks in the down position, press
the lift switch down to allow the mower decks to float and
mow.
Note: The decks do not lower while in the High-speed range
and they do not raise or lower if the operator is out of the seat
when the engine is running. Also, the decks lower with the
key in the O
Cruise-Control Switch
The cruise-control switch locks in the pedal position to
maintain the desired ground speed
rear of the switch turns off the cruise control, the middle
position of the switch enables the cruise-control function,
g028453 and the front of the switch sets the desired ground speed.
Note: Pressing either brake pedal or moving the traction
pedal into the R
disengages the pedal position.
g028454
1. Power-point port
14
UT
range, raise the decks, disengage the PTO,
OW
position and the operator in the seat.
N
(Figure
position, for 1 second, also
EVERSE
1
2
Figure 5
2. Cruise-control switch
( ) and I ( ).
START N STOP
(Figure 4).
(Figure
5). Pressing the