Checking The Torque Of The Wheel-Lug Nuts; Adjusting The Rollover Protection System (Rops) - Toro 30605 Operator's Manual

Checking the Torque of the
Wheel-Lug Nuts
Service Interval: After the first hour
After the first 10 hours
Every 200 hours
Torque the wheel-lug nuts to 115 to 136 N∙m (85 to 100 ft-lb)
in the order shown in Figure 10
Front Wheels
Rear Wheels
WARNING
Failing to maintain proper torque of the wheel-lug
nuts could result in personal injury.
Torque the wheel-lug nuts to the proper torque
value.
and Figure 11.
Figure 10
Figure 11
Adjusting the Rollover
Protection System (ROPS)
WARNING
To avoid injury or death from rollover: keep the
roll bar in the raised locked position and use the
seat belt.
Ensure that the seat is secured with the seat latch.
WARNING
There is no rollover protection when the roll bar is
in the down position.
• Do not operate the machine on uneven ground
or on a hill side with the rollover protection in
the down position.
• Lower the roll bar only when absolutely
necessary.
• Do not wear the seat belt when the roll bar is
in the down position.
• Drive slowly and carefully.
• Raise the roll bar as soon as clearance permits.
• Check carefully for overhead clearances (i.e.,
branches, doorways, electrical wires) before
driving under any objects and do not contact
them.
Important: Always use the seat belt when the roll bar
is in the raised and locked position. Do not use the seat
belt when the roll bar is in the lowered position.
22