Mitsubishi Electric MELSEC-Q Structured Programming Manual page 298

FXCPU Structured Programming Manual
[Device & Common]
4. On the "Ethernet Port" tab, click the "Time Setting" button.
On the "Ethernet Port Time Setting" dialog box, set the SNTP server IP address and others.
Set item
SNTP Function Setting
SNTP Server IP Address
Input Format
Time Zone
Execute time setting at turn ON
On-error Action
Execution Interval
*1
Execution Time
*1. Only either one can be selected between "Execution Interval" and "Execution Time".
5. Click the "END" button to finish the setting and close the "Ethernet Port Time Setting "
dialog box.
296
Select whether to use the time setting function.
Set SNTP Server IP Address.
Select the input format used to set the SNTP server IP address.
Select the time zone for synchronizing the time among the following
choices:
GMT-12:00, GMT-11:00, GMT-10:00, GMT-9:00,
GMT-8:00, GMT-7:00, GMT-6:00, GMT-5:00,
GMT-4:00, GMT-3:30, GMT-3:00, GMT-2:00,
GMT-1:00, GMT, GMT+1:00, GMT+2:00, GMT+3:00,
GMT+3:30, GMT+4:00, GMT+4:30, GMT+5:00,
GMT+5:30, GMT+5:45, GMT+6:00, GMT+6:30,
GMT+7:00, GMT+8:00, GMT+9:00, GMT+9:30,
GMT+10:00, GMT+11:00, GMT+12:00, GMT+13:00
Check this item to execute time setting when the power of the PLC
main unit is turned ON.
Select whether processing is continued or stopped if an error occurs in
the time setting executed when the power of the PLC main unit is
turned ON.
*1
Specify the time interval to execute time setting.
Specify the time (in increments of 30 minutes) to execute time setting.
Contents of setting
6 Types and Setting of Parameters
6.6 Parameter setting by GX Works2
Setting range
-
0.0.0.1 to 223.255.255.254
(Decimal)
00.00.00.01 to DF.FF.FF.FE
(Hexadecimal)
DEC, HEX
As shown on the left
-
-
1 to 1440 min
-