Petalinux Demo Hardware Setup Instructions - Xilinx Spartan-6 FPGA SP605 Embedded Kit Getting Started

Introduction

PetaLinux Demo Hardware Setup Instructions

1.
2.
Table 4: SP605 Jumper Settings
Jumper REFDES
3.
4.
Table 5: PetaLinux Demo System ACE DIP Switch Settings
Note:
settings for the Video Demo, not the PetaLinux Demo.
5.
6.
Note:
for the Video demo.
16
Install the USB-UART driver to your host computer by executing the steps specified in
the Communicating with the SP605 USB-UART
Confirm that the SP605 jumper settings are at default, as shown in
J19 Exclude FMC LPC connector J2
J22 SFP Full BW
J44 SFP Enabled
J46 SPI Select SPI X4 Memory U32
J60 System ACE CF Error LED DS18 Enabled
Insert the provided Compact Flash card into the board as shown in
Set the System ACE DIP switches as shown in
DIP Switch
1
2
3
4
This is the same DIP switch as shown in
If the SP605 board is not powered on, plug in the power adapter to local AC power.
Plug the 12V power cable into the board connector on J18. Turn on the power by
switching the SW2 to the "ON" position.
Open and configure a serial communications terminal utility program with the
following settings:
• Baud Rate: 115200
• Data: 8 bit
• Parity: None
• Stop: 1 bit
• Flow Control: None
Note: The baud rate (115200) for the PetaLinux demo is not the same baud rate (9600) used
www.xilinx.com
section.
Function
FMC JTAG Bypass
SFP Module
SPI Memory Select
System ACE CF Error LED
Table 5.
Switch Position
On
Off
Off
On
Figure 3
. However,
Table 4.
Default
Jump 1-2
Jump 1-2
Jump 1-2
Jump 1-2
Jump 1-2
Figure 3.
Figure 3
shows the switch
SP605 Getting Started Guide
UG727 (v1.1) June 21, 2010