Xilinx Spartan-6 FPGA SP605 Embedded Kit Getting Started page 28

Installation and Licensing of ISE Design Suite 12.1
6.
X-Ref Target - Figure 23
Note:
the computer might be required. After rebooting, repeat step 5 and step 6.
7.
X-Ref Target - Figure 24
8.
28
Expand the Ports (COM & LPT) entry as shown in
port assigned to the Silicon Labs CP210x USB to UART bridge. This is the COM port to
use in the serial communications program.
Figure 23: Silicon Labs USB to UART Bridge Properties
If the Silicon Labs CP210x USB to UART bridge does not appear in the Ports list, a reboot of
If you are using TeraTerm as your serial communications utility program, right-click
on the Silicon Labs CP210x USB to UART bridge and select Properties.
a. Click on the Port Settings tab and then click Advanced.
b. Set the COM port to an open COM port setting from COM1 to COM4. Note that
the COM port setting for your system may not be the one shown in
Figure 24: Setting the COM port for the Silicon Labs USB to UART Bridge Driver
Click OK to exit all open windows.
www.xilinx.com
Figure 23. This shows the COM
UG727_25_051110
Figure
UG727_26_111309
SP605 Getting Started Guide
UG727 (v1.1) June 21, 2010
24.