Setting Up Ip30 Tele; Setting Up Check Point Fp3 - Nokia IP30 User Manual

4
VPN Configuration
dynamic object. This topology uses a remote access VPN
community.
An illustration of this topology is available in Figure 8.
IP30 Tele uses only a manual mode VPN connection. To select the
VPN gateway to which you want to establish a VPN connection, go
to http://my.vpn.

Setting up IP30 Tele

To configure a VPN Tunnel between an IP30 Tele and Check Point
FP3, on IP30 Tele (VPN client) add a VPN site.

Setting up Check Point FP3

Configure a Safe@gateway dynamic object on the Check Point
SmartBoard.
To set up Check Point FP3
1. Create a Safe@gateway as a dynamic object.
2. Create a user and add the user to the VPN users group.
3. Create a remote access VPN community.
4. In the policy editor, create a rule with
98
Include FP3 firewall object in the participating gateway.
Include the Users group in the participating users.
Source User - any
Destination - any
Via - remote access community
Target - FP3 firewall object
Nokia IP30 User Guide