Table of Contents
Advertisement
2. Click the Firmware tab.
The Firmware page appears.
The Firmware page displays a table with the following information:
Firmware Version - the current version of the firmware.
Hardware Type - the type of the current IP30 hardware.
Hardware Version - the current hardware version of the IP30.
Installed Product -the licensed software and the number
allowed nodes.
Uptime - the time that elapsed from the moment the unit was
turned on.
Resetting the IP30 to factory defaults
The IP30 allows you to reset its settings to factory defaults. When
you reset the IP30, it reverts to the state it was originally in when
you purchased it, and your firmware reverts to the version that
shipped with the IP30.
You can reset to factory defaults using the GUI or by manually
pressing the Reset button located at the back of the IP30.
Warning
This operation erases all your settings and password information. You will
have to set a new password and reconfigure the IP30 for Internet
connection.
To reset the IP30 to factory defaults using GUI
1. In the Navigation Bar click Setup.
The Internet page appears.
2. Click the Firmware tab.
The Firmware page appears.
3. Click Factory Settings.
IP30
Frequently Asked Questions
131
Advertisement
Table of Contents
