1
PART NAMES
This chapter describes the names of each part of the RJ71PN93.
(1)
(2)
(3)
(4)
No.
Name
(1)
RUN LED
ERR LED
TEST LED
BF LED
(2)
Ethernet port (P1)
SD/RD LED
(3)
Ethernet port (P2)
SD/RD LED
(4)
Production information marking
*1 The Blink command remotely flashes the LED on the target device. This command shows the physical location of the target device
selected on the PROFINET configuration tool. ( Manual of the IO controller or PROFINET configuration tool used)
*2 The BF LED is turned off during exchanging I/O data regardless of the 'IO data receive error' (X2) status.
The LED indication when operation mode is the automatic hardware test, refer to the following.
MELSEC iQ-R PROFINET IO Device Module User's Manual (Application)
1 PART NAMES
16
Description
Indicates the operating status.
On: Normal operation
Off: Error ( MELSEC iQ-R PROFINET IO Device Module User's Manual (Application))
Indicates the error status of the RJ71PN93.
On, flashing: Error ( MELSEC iQ-R PROFINET IO Device Module User's Manual (Application))
Off: Normal operation
Indicates the receive status of the Blink command.
Flashing: Blink command received from an external device
Off: Blink command not received
Indicates the communication status with the IO controller.
On: I/O data exchanges stopped
*2
Off: I/O data exchanging
A connector for PROFINET connection. Connect an Ethernet cable.
For wiring methods and wiring precautions, refer to the following.
Page 29 WIRING
Indicates the data sending/receiving status.
On, flashing: Data being sent or received
Off: Data not sent nor received
Same as Ethernet port (P1)
Indicates the production information (16 digits) of the RJ71PN93.
*1