Wiring Products - Mitsubishi Electric MELSEC iQ-R Series User Manual

6.2

Wiring Products

This section describes the devices used for PROFINET.
PROFINET devices
Ethernet cables must be prepared by users. For details on Ethernet cables, refer to the following.
• PI: www.profibus.com
A communication error may occur due to high-frequency noise from devices other than a programmable
controller in a given connection environment. The following describes countermeasures to avoid high-
frequency noise influence.
Wiring
• Do not install cables together with the main circuit lines or power cables.
• Place cables in a duct.
Switching hub
Use switching hubs that support the transmission speed of communication when using switching hubs in PROFINET.
When the industrial managed switch (NZ2MHG-T8F2) is used, use the industrial managed switch (NZ2MHG-T8F2) with the
production information (first six digits) of 7104AV or later.
6 WIRING
30
6.2 Wiring Products