Checking The Tire Pressure; Checking The Torque Of The Wheel-Lug Nuts - Toro Groundsmaster 5910 Operator's Manual

•
Monitor seals, hoses, and gaskets in contact with fuel as
they may degrade over time.
•
Fuel-filter plugging may be expected for a time after
converting to biodiesel blended.
•
Contact your distributor if you wish more information
on biodiesel.
Filling the Fuel Tank
Note: If possible, fill the fuel tank after each use. This
minimizes possible buildup of condensation inside the fuel
tank.
Figure 19

Checking the Tire Pressure

Service Interval: Before each use or daily
The correct air pressure in the front tires is 345 kPa (50 psi )
and the rear tires is 207 kPa (30 psi) as shown in
Important: Maintain pressure in all tires to ensure a
good quality of cut and proper machine performance.
Do not underinflate the tires.
Check the air pressure in all the tires before operating
the machine.
Checking the Torque of the
Wheel-Lug Nuts
Service Interval: After the first 10 hours
Every 250 hours
WARNING
Failure to maintain the proper torque of the wheel
nuts could result in failure or loss of a wheel, and
may result in personal injury.
Torque the front and rear wheel nuts to 95 to 122
N·m (70 to 90 ft-lb) after 10 hours of operation.
Torque the nuts every 250 hours thereafter.
26
(Figure
Figure 20
20).