Panasonic LP-GS Series Serial Communication Command Manual page 81

Name Omit
Font No. Y
Character
Y
spacing type
Character
(Y)
arrangement
Rotation angle Y
Character
spacing
or Y
Character
string width
Linefeed
Y
spacing
Laser power
Y
correction
Scan speed
Y
correction
Total data length
* Setting request data are variable length.
2. When the character arrangement is arc
Name Omit
Object No. –
Center
Y
X-position
Center
Y
Y-position
Character
Y
height
Character width Y
Horizontal
Y
alignment
System
Y
reserved value
Data
length Data contents
[byte]
Max. 2* "01"–"50"
"0": Fixed spacing
"1": Proportional 1
1 "2": Proportional 2
"3": Proportional 3
"4": Justify
1 "0": Straight line (horizontal)
Max. 8* "-180.000"–"+180.000" [°]
Model
Max. 7* LP-GS051(-L)
LP-GS052
LP-RC350S
LP-RF200P
Max. 7*
Max. 3* "000"–"999" [%]
Max. 3* "001"–"999" [%]
Max. 88 It is the length including the separator ",".
Data
length Data contents
[byte]
Max. 4* "0000"–"1999"
Max. 8*
"-999.999"–"+999.999" [mm]
Max. 8*
Model
Max. 7*
LP-GS051(-L)
LP-GS052
LP-RC350S
Max. 7*
LP-RF200P
"0": Left
1 "1": Center
"2": Right
1 "0" or omit
ME-LPGS-SR-5
With "Justify" setting in straight line,
if the value of character width x digit
number is smaller than the character
string width, the character width is
adjusted narrower automatically.
The rotation center is the origin of
the character strings.
Setting range [mm]
Specifies a character spacing for
"000.000"–"055.000" fixed spacing/proportional, and a
character string width for justify.
"000.000"–"030.000"
"000.000"–"085.000"
"000.000"–"090.000"
The correction ratio is calculated
using the value set at the laser
settings as 100%.
Specifies coordinates of the center
of a circle to form an arc.
Setting range [mm]
To make the characters bold, set
"000.100"–"055.000"
the ratio of the character height and
"000.060"–"030.000"
width not to be other than the range
"000.100"–"085.000"
from 1/10 to 10.
"000.100"–"090.000"
• Specifies which point of the entire
• The horizontal alignment is the
Remarks
Remarks
character strings you use as the
origin for the character object
selected.
base position of the start angle of
an arc.
81