Panasonic LP-GS Series Serial Communication Command Manual page 144

⿎ Data description
Name
Line speed
Workpiece reference
boundary
Workpiece spacing
Lasing start
boundary
Overrun correction
Total data length
* Setting request data are variable length.
⿎ Example of command settings
Condition: Line speed = 80, Workpiece reference boundary = 5, Lasing start boundary = 20,
Overrun correction = 0
• Setting
Transmission data
• Readout
Transmission data
Response data
144
Data
Omit length
[byte]
Y Max. 7* "000.060"–"240.000" [m/min.]
Y Max. 9* "-2000.000"–"+2000.000" [mm]
Y Max. 8* "0000.000"–"4000.000" [mm]
Model
Y Max. 8*
LP-RC350S
LP-RF200P
Y Max. 4* "-100"–"+100"
Max. 40 It is the length including the separator ",".
[STX] FLF
[STX] FLF
[STX] FLF
Data contents
Setting range [mm]
"-042.500"–"+042.500"
"-045.000"–"+045.000"
S 80,5,,20,0 [CR]
R [CR]
A 080.000,+0005.000,0100.000,+020.000,+000
ME-LPGS-SR-5
Remarks
Only when line speed control
is set to "fixed speed", set this
value.
For other line speed controls,
omit this setting.
Only when trigger mode is set to
"Marking at regular intervals", set
this value.
For other trigger modes, omit this
setting.
• Specifies the boundary
position in the marking field.
When the workpiece reaches
this boundary, the lasing
starts.
• The plus value indicates
the upstream of the
moving direction and the
negative value indicates the
downstream side.
If the start position of the
character are distorted, set the
larger value.
The larger the setting value result
in the longer marking time.
[CR]