Motion Settings For Current File: Flf - Panasonic LP-GS Series Serial Communication Command Manual

Name Omit
Distance line
Y
speed sensors
2 Sensors input
Y
time-out
Total data length
* Setting request data are variable length.
Reference
• Any of the following functions that are not available with on-the-fly marking are configured.
• Link control with external image checkers
• Overwriting interval
• Skip marking of 2D code (Setting of module marking order)
• When the trigger mode is set to Marking at regular intervals or Multiple triggers, those functions are also not available.
• Registered characters (via I/O)
• External Offset including SEO command
• Characters specified by SIN command
• Counter reset at date change
• The setting changed by this command is saved in the laser marker without overwriting to the file.
⿎ Example of command settings
Condition: On-the-fly marking ON/OFF = 1, Moving direction = 0, Trigger mode = 0,
Trigger detecting position = 200, Line speed control = 1, Encoder resolution = 120.5
• Setting
Transmission data
• Readout
Transmission data
Response data

3-12-2 Motion settings for current file: FLF

Supported model: LP-RC series, LP-RF series
Sets the detailed parameters of on-the-fly marking for the selected marking file, such as the line speed, lasing start
boundary and etc.
⿎ Setting request data / response data for readout
Start Sub
FLF
code command
Sub command is "S" for the setting request data and the initial setting "A" for the response data for readout.
⿎ Readout request data
Start
FLF R
code
Data
length Data contents
[byte]
Max. 7 * "001.000"–"999.999" [mm]
"00": None
Max. 2 *
"01"–"10" [sec.]
Max. 35 It is the length including the separator ",".
[STX] FLY S
[STX] FLY R
[STX] FLY A
[Line speed], [Workpiece reference boundary],
[Workpiece spacing], [Lasing start boundary],
[Overrun correction]
Max. 40-byte
(Check sum) End code
ME-LPGS-SR-5
Only when line speed control is set to "2
sensors input", set this value.
For other line speed controls, omit this
setting.
1,0,0,200,1,120.5 [CR]
[CR]
1,0,0,0200.000,1,120.500,010.000,10
Remarks
[CR]
(Check
End code
sum)
143