Object Movement: Por - Panasonic LP-GS Series Serial Communication Command Manual

3-11-2 Object movement: POR

Sets the base position of the marking object using the relative value from the current position.
⿎ Setting request data
Start
POR
code
⿎ Data description
Name
Object No.
X-movement
Y-movement
Rotation movement
Total data length
* Setting request data are variable length.
⿎ Example of command settings
Condition: Object No. = 1, X-movement = 5, Y-movement = -0.5, Rotation movement = 180,
Object No. = 2, X-movement = 5, Y-movement = -2, Rotation movement = 180
• Setting
Transmission data
124
[Object No.], [X-movement],
[Y-movement], [Rotation movement]
S
(, [Object No.], [X-movement],
[Y-movement], [Rotation movement]...)
Data length
Omit
[byte]
– Max. 4* "0000"–"1999"
Y Max. 8*
"-999.999"–"+999.999" [mm]
Y Max. 8*
Y Max. 8* "-180.000"–"+180.000" [°]
It is the length including the separator ",".
Max. 31 The maximum value that can be set to one object number.
Max. 32 objects can be set at once.
[STX] POR
Data contents
• It is the movement to the coordinate
• The movement of the item omitted will
• For the point radiation object, specify
S 1,5,-0.5,180,2,5,-2,180
ME-LPGS-SR-5
(Check
End code
sum)
Remarks
specified in the object settings. Set
a relative value to the value currently
set.
be set to 0.
the movement value from the current
X-/Y-offset and rotation angle applied
to the all radiation points set in the
specified object number.
[CR]