Panasonic LP-GS Series Serial Communication Command Manual page 56

Type Name
Laser settings
Laser correction by object
Pulse cycle correction by object *3
Laser radiation for measurement
Error code
Alarm reset
System clock
Command mode
*1 : Only LP-RC series, LP-RF series
*2 : Only LP-GS051(-L) type, LP-RC350S, LP-RF series
*3 : Only LP-RF series
56
Code Functions
LSC Sets the laser settings for the entire file such as
laser power and scan speed.
MOD Sets the correction value if you change laser
settings for each object.
PCC Sets the correction value of laser pulse cycle for
LP-RF series by each object.
SPT Controls "laser radiation for measurement" used to
measure laser output by a commercially available
power meter.
ENO Reads out the error code of alarm or warning when
an error has occurred.
ARS The reset input for restoring the system from the
alarm status.
YMD Sets the date and time of the system clock of the
laser marker.
RSM Switches the command mode between LP-400/
LP-V compatible mode and the standard one.
This command is available when LP-400/V
compatibility setting is enabled in system settings.
ME-LPGS-SR-5
Refer
(P.145)
(P.147)
(P.149)
(P.151)
(P.153)
(P.153)
(P.154)
(P.155)