External Offset Values: Ofs - Panasonic LP-GS Series Serial Communication Command Manual

3-11-7 External offset values: OFS

Sets offset value of marking position and laser power for the entire file data used for "External Offset Function" with I/O
input.
⿎ Setting request data / response data for readout
Start
OFS
code
Sub command is "S" for the setting request data and the initial setting "A" for the response data for readout.
⿎ Readout request data
Start
OFS
code
⿎ Data description
Name Omit
Data number –
X-movement Y
Y-movement Y
Z-movement Y
Rotation
Y
movement
Laser power
Y
correction
Total data length
* Setting request data are variable length.
Reference
• This command can be used when the input method of the external offset is I/O input setting. If "Using SEO command" is
set, refer to "3-11-5 Marking position and laser power adjustment per trigger: SEO" (P.128) for entering the offset values.
• When any of the data item is omitted, the data set last (the initial value if it was not set) will be maintained for the omitted
field.
132
[Data number], [X-movement], [Y-movement],
Sub
command [Rotation movement], [Laser power correction]
[Data number]
R
Max. 4-byte
Data
length
[byte]
Max. 4* "0000"–"1023"
Max. 8*
"-999.999"–"+999.999" [mm]
Max. 8*
Model
LP-GS051
LP-GS052
Max. 8*
LP-GS051-L
LP-RC350S
LP-RF200P
Max. 8* "-180.000"–"+180.000" [°]
Max. 3* "000"–"999" [%]
Max. 44 It is the length including the separator ",".
[Z-movement],
Max. 44-byte
(Check sum)
Data contents
Setting range [mm]
"-003.000"–"+003.000"
"-001.500"–"+001.500"
"+000.000" or omit
ME-LPGS-SR-5
(Check
End code
sum)
End code
Remarks
Specifies the data number for
which the external offset is set.
• Moves the coordinate of the all
marking data in the file.
• Z-movement cannot be
specified with LP-GS051-L, LP-
RC and LP-RF series.
• The rotation center is the center
of the marking field.
Corrects the laser power of the all
marking data in the file.
It is the correction ratio relative to
the setting laser power.