Panasonic LP-GS Series Serial Communication Command Manual page 150

Code type
GS1 DataBar
Composite code
Reference
• Only when the request data contains the object number with the value after the decimal point, the object number of the
response data contains the value after the decimal point.
• For the point radiation object, the laser pulse cycle of the all radiation points set in the specified object number is
adjusted by this command. It is not possible to specify the laser pulse correction value of the each radiation point.
⿎ Example of command settings
Condition: Object No. = 0, Laser pulse cycle correction = 80
Object No. = 1, Laser pulse cycle correction = 100
• Setting
Transmission data
Condition: Object No. = 0
• Readout
Transmission data
Response data
150
Content
".0": Code symbol (For composite code, 1D side setting)
".1": Code symbol of 2D side (Composite code only)
".2": Separator of Stacked (GS1 DataBar Stacked (CC-A) only)
".3": Separator of composite code (Composite code only)
".8": Human readable text
[STX] PCC S 0,80,1,100
[STX] PCC R 0
[STX] PCC A 0000,080
ME-LPGS-SR-5
[CR]
[CR]
[CR]