Panasonic LP-GS Series Serial Communication Command Manual page 110

Name
Marking ON/OFF
or
Custom pattern ON/
OFF
Laser power
correction
Scan speed
correction
Total data length
* Setting request data are variable length.
⿎ Example of command settings
Condition: Object No. = 1, Code element = 2, Marking ON/OFF = 1, Laser power correction = 150,
Scan speed correction = 80
• Setting
Transmission data
• Readout
Transmission data
Response data
110
Data length
Omit
[byte]
With code element "1", "2" or "3":
"0": Marking OFF
"1": Marking ON
– 1
With code element "4" or "5":
"0": Custom pattern OFF
"1": Custom pattern ON
Y Max. 3* "000"–"999" [%]
Y Max. 3* "001"–"999" [%]
Max. 16 It is the length including the separator ",".
[STX] BRP
[STX] BRP
[STX] BRP
Data contents
S 1,2,1,150,80
R 1,2 [CR]
A 0001,2,1,150,080
ME-LPGS-SR-5
Remarks
• Marking on/off of the selected
element in the 2D code. With this
setting, the inversion of black and
white for the 2D code marking is
specified.
• Switching the on/off setting of the
dark and light module inverts black
and white for the marking.
• With setting "0": Mark OFF, end
the data here. No subsequent data
including a separator "," is required.
• If the alignment/finder/border is
marked using the other custom
pattern than the module, set "ON"
here.
• When the alignment/finder pattern
of QR code is set to "Custom pattern
OFF", marking is performed using
the filling pattern of the dark/light
module.
• When the border pattern of data
matrix is set to "Custom pattern
OFF", marking is performed using
the filling pattern of the dark module/
light module.
• With setting "0": Custom pattern
OFF, end the data here. No
subsequent data including a
separator "," is required.
The correction ratio is calculated using
the value set at the laser settings as
100%.
[CR]
[CR]