Figure 5-31 Ip Address Setup Window - Hitachi FL.NET User Manual

(1) IP address/subnet setup precautions
For the FL.NET module, you can freely set the IP address and subnet mask. However, you
must comply with the FL-net protocol. It is therefore recommended that you use Class C
for IP address setup and set the network address to 192.168.250. Also, be sure that the
subnet mask setting is 255.255.255.0.
Note 1: If all the IP address entries are set to 0 or 255, an input error occurs.
Note 2: If all the host number entries are set to /0 or /F, the FL.NET module performs the
same process as in cases where IP address setup is not completed.
Note 3: If the FL.NET module is not installed, the IP address setup window of the setup tool
named [S10V FL.NET SYSEM] indicates the physical address /FFFFFFFFFFFF.
If the FL.NET module is installed but IP address setup is not completed, the window
shows the physical address /000000000000.
Note 4: When referencing the physical address, install the FL.NET module and set the IP
address. The IP address and subnet mask can be referenced even if the FL.NET
module is not installed.
Note 5: If the IP address is not set, with the LER LED on the FL.NET module blinking.

Figure 5-31 IP Address Setup Window

5-29
5 USER GUIDE
Ensure that the
subnet mask setting
is 255.255.255.0.