Hitachi FL.NET User Manual page 204

(2) Checking the IP address with the personal computer's "ping feature"
The connection and IP address setting for the target FL-net device can be checked without
using the FL-net network analyzer or any other special tool. Such a check can also be
conducted with the "Ping feature" of a general-purpose personal computer or the like. The
table below outlines the IP address checkout procedure that is to be performed with the "Ping
feature."
The IP connection can be checked with the "Ping" command. The procedure is outlined
below.
① Select Start
display [Command Prompt].
② Enter the "Ping" command to conduct a basic communication test for the purpose of
checking the communication between the link unit and personal computer. To make a
Ping command entry, type in "Ping [IP-address]" or "Ping [host-name] ."
Example (IP address): Ping 192.168.250. 13
When the target FL-net device is properly set, the following message is displayed.
Pinging 192.168.250. 13 with 32 bytes of data
Reply from 192.168.250. 13: bytes=32 time=2 ms TTL=32
Reply from 192.168.250. 13: bytes=32 time=1 ms TTL=32
Reply from 192.168.250. 13: bytes=32 time=1 ms TTL=32
Reply from JEMA 192.168.250. 13 : bytes=32 time=1 ms TTL=32
C: \WINDOWS>
③ If an NG result is obtained (the connection is not verified), the following timeout
indication is displayed.
Pinging 192.168.250. 13 with 32 bytes of data:
Request timed out.
Request timed out.
Request timed out.
Request timed out.
C: \WINDOWS>
button – [(All) Programs] – [Accessories] – [Command Prompt] to
7-5
7 TROUBLESHOOTING