Setup Ip Address - Hitachi FL.NET User Manual

5 USER GUIDE
5.5.10

Setup IP address

Online editing
Function: Set the IP address of the FL.NET module.
For using this function, it is a prerequisite that the PCs is connected with the PC by cable.
Note: Setting the IP address or subnet mask for the FL.NET module resets the programmable
controller automatically.
Operation: The procedure is shown below.
(1) Select [IP address] from the [Module] menu of the [[S10V] FL.NET] window.
(2) The [[Online] Setup IP address] window is displayed. Enter the IP address and subnet
mask.
(3) After completing the setup, click the
Close button.
(4) Upon completion of the setup, the message dialog box shown below appears. Contact the
facility manager and check if the programmable controller is resettable now. If it is
resettable, click the
automatically reset. Upon completion of the resetting, the "Sending terminated" message
dialog box appears. Click the
Write
OK button. The programmable controller will then be
OK button.
5-134
button. To cancel the setup, click the