How To Check Operation Of Fixing Belt/Pressure Belt Displacement Correction Control; How To Display Log Of Fixing Belt Displacement Control Steering Setting Values/How To Check Operation Of Displacement Control - Canon imagePRESS C800 Series Troubleshooting Manual

If any of following situations matches, implement each respective situation mode.
Installation
ITB Initial Settings
Left Edge Margin Adjustment (1st side): Cassette
Leading Edge Margin Adjustment (1st side)
Left Edge Margin/Leading Edge Margin Adjustment (2nd side)
Troubleshooting
Development stain
Transfer Failure on Trailing Edge of Coated Paper
Calibration for Color Difference on Front and Back Sides
Scratch on Fixing Belt Caused by Paper Edge
Development coating failure
Major Adjustment
Left Edge Margin Adjustment (1st side): Cassette
Leading Edge Margin Adjustment (1st side)
Left Edge Margin/Leading Edge Margin Adjustment (2nd side)

1.1.7.1.53 How to check operation of Fixing Belt/Pressure Belt Displacement Correction Control

[ Manual-related ]
Description
Please explain how to check the operation of Fixing Belt/Pressure Belt Displacement Correction Control.
Field Remedy
Select Service Mode > COPIER > Function > FIXING > select FX-UHP (Fixing Belt) or FX-LHP (Pressure Belt) > press OK key.
During any of these operations, "ACTIVE" is indicated, "OK!" is indicated after the completion and "NG" is indicated after the time-out.
1.1.7.1.54 How to display log of Fixing Belt Displacement Control Steering setting values/How to check operation of
displacement control
[ Manual-related ]
Description
Parts Replacement
Adjustment during Main Controller PCB 2 Replacement
Adjustment during DC Controller PCB Replacement
Adjustment during HDD Replacement
Adjustment during Laser Scanner Unit Replacement
Adjustment during Primary Charging Wire Replacement
Adjustment during Grid Plate Replacement
Adjustment during Primary Charging Assembly Replacement
Adjustment during Pre-transfer Charging Wire Replacement
Adjustment during Drum Unit Replacement
Adjustment during Developing Assembly Replacement
Adjustment during Potential Sensor Replacement
Adjustment during Primary Transfer Roller Replacement
Adjustment during Patch Sensor Unit Replacement
Adjustment during Waste Toner Container Replacement
Adjustment during Fixing Belt Unit Replacement
Adjustment during Pressure Belt Unit Replacement
Adjustment during Fixing Assembly Replacement
Chapter 1
0031-6216
0031-6218
1-143