Table of Contents
Advertisement
4-3-1 (10) Automatic address setting (for reference)
In case to decide address (Line / Group / Indoor address) by automatic address setup, be sure to
change these address to match the address setting table for TCS-NET control system.
→ → → → → "4-3-1 (2) Manual setting from wired remote controllr",
→ → → → → "4-3-1 (13) Address change from remote controller"
If unmatched address is allocated, a problem such as error of communication with air conditioner
will occur.
Address setup flow (In case automatic address setup)
Setting flow
Line addrss setting
Power - ON
Automatic address setting
Trial operation
Manual address setting
or
Address change from remote controller
Setup of relay connector and SW30-2
Central controller exist ?
Central control device setting
Trial operation (Central control device)
TCS-NET control system address setting
Intelligent server
TCS-NET relay I/F
Energy monitoring I/F
Digital I/O relay I/F
Trial operation for Touch panel controller
CAUTION
Contents
Line address settting
Check at Power-ON
Refer to this section "4-3-1 (10)
Trial operation
Manual setting from remote controller
Address change from remote
controller
Setup of relay connector and
terminator
Central control address setting
Test run for central controller
Address setting for TCS-NET control
system
74
Reference No.
4-3-1
4-3-1
4-3-1 (6)
4-3-1 (2)
4-3-1 (13)
4-3-1 (7)
4-3-1 (8)
4-3-1 (9)
4-4
Chapter. 5
Advertisement
Table of Contents
