Table of Contents
Advertisement
Flow chart of setting central control address (digest)
(In case of central remote controller TCB-SC642TLE)
Method
Automatic setting from central
remote controller (TCB-SC642TLE)
(1) Press the
and
the same time for more than 4 sec.
(2) Select CODE No. C2 by
pressing setup temp.
buttons.
(3) Press the
button.
SET
("C2" changes from flashing to
ON state and automatic setting
will start.)
(4) Finishing automatic setting,
changes from flashing to
OFF.
(5) Press the
button.
(6)
flashes for a few minutes,
then OFF.
Checking duplication of central control address.
(1) Press
Central remote controller
(TCB-SC642TLE)
(For detailed setting procedure, refer to installation manual attached
central control devices.)
Automatic setting
buttons at
Setting from central remote controller
Manual setting from central
remote controller (TCB-SC642TLE)
(1) Press the
the same time for more than 4 sec.
(2) Set CODE No. to C1 using
setup temp.
(3) Press the
(4) Select the zone and group No.
with
(Group) buttons.
(5) Set the Unit No. (Indoor and line
address) with
(6) Press the
(7) Register the other Unit No. in
the same way following the
steps (4) to (6).
(8) Press the
(9)
then OFF.
(10)End
1 by 1 model
button three times.
If any duplication is discovered, error code "L20" is displayed.
Wired remote controller : Displayed promptly.
Central remote controller : Max. 4 min. later.
Method
and
buttons at
buttons.
button.
SET
and
and
buttons.
button.
SET
button.
flashes for a few minutes,
Digital Inverter
Super Digital Inverter
72
Completion of indoor unit
addresses
Yes
Automatic
setting?
No
Manual setting
No
Set from wired
remote controller?
Setting from wired
Yes
remote controller
Method
Manual setting from wired remote
controller (RBC-AMT21E)
(1) Press the
and
buttons at the
same time for more than 4 sec.
(Don't press
button.)
UNIT
(2) Set CODE No. to 03 using setup
temp.
buttons.
(3) Set the central control address
using timer
buttons.
(4) Press the
button to register
SET
the address.
(
indications changes from
flashing to ON state.)
(5) Press the
button.
(6)
indications changes from
ON state to flashing.
(approx. 1 minute.)
(7) End
No
VRF* system?
Yes
Checking from central remote controller
for duplication of central control address
(1) Press the
and
buttons at the
same time for more than 4 sec.
(2) Select CODE No. C3 using setup
temp.
buttons.
(3) Press the
button.
SET
(4)
indication flashes and central
control address duplicated error check
starts.
(5) The check is completed when CODE
No. C3 flashes and
(6) If any duplication is discovered, the
GROUP No. will flash.
The central control address is cleared
by selecting the data where GROUP
No. is flashing and by pressing the
button.
Set the correct central control address.
Duplication?
No
(No duplication)
End
*Super MMS
Super HRM
goes off.
CL
Yes
(Duplication is
discovered.)
Advertisement
Table of Contents
