Assigning Parameters To The Encoder Mode Assign Buttons - Yamaha 02R96 Owner's Manual

Assigning Parameters to the ENCODER MODE Assign Buttons

Up to two parameters can be assigned to the two ENCODER MODE ASSIGN buttons.
Initially, the following parameters are assigned to the ASSIGN buttons:
[ASSIGN 1]: Input Patch
[ASSIGN 2]: Direct Out
1 Use the ENCODER MODE [DISPLAY] button to select the Encoder Mode
Assign page.
The names of the parameters currently assigned to each ASSIGN button are displayed in the
left-hand box. The parameter currently assigned to the selected ASSIGN button appears
highlighted in the right-hand box.
Press an ASSIGN button, or use the Up/Down cursor buttons, to select an
2
ASSIGN button.
3 Use the Parameter wheel, or the INC/DEC buttons to select a parameter.
A parameter is selected when it appears inside the dotted box.
See the "Assignable Encoder Mode Parameter List" on page 38 for a complete list of assign-
able parameters.
Press the [ENTER] button to assign your choice.
4
Once assigned, the selected parameter appears highlighted in the right-hand box.
When channels that do not feature the currently assigned parameter are selected, the
Encoders are inactive. For example, if the assigned Encoder parameter is "Phase," and the
Master Layer is selected, Encoders 9–24 are inactive, because the Aux Sends and Bus Outs
do not feature Phase parameters.
Assigning Parameters to the ENCODER MODE Assign Buttons
37
02R96—Owner's Manual