Auto Pan - Yamaha 02R96 Owner's Manual

246
Appendix A: Parameter Lists

AUTO PAN 5.1

Six input, six output autopanner for 5.1 surround. You can reset to the pan position speci-
fied by the OFFSET parameter by pressing the RESET button.
Parameter
SOURCE
TRIG. LVL
TIME
SPEED
DIR.
OFFSET
HPF
LPF
CHORUS 5.1
Six input, six output chorus for 5.1 surround.
Parameter
FREQ.
AM DEPTH
PM DEPTH
MOD. DLY
WAVE
HPF
LPF
SYNC
NOTE
1.
02R96—Owner's Manual
Range Description
When set to OFF, the TRIGGER button is used to start auto-
pan. When set to HOLD, autopan runs continuously. When
OFF, HOLD, INPUT,
set to INPUT, the input signal triggers autopan. When set to
MIDI
MIDI, a MIDI Note On message can be used to trigger auto-
pan.
Input trigger level (i.e., the signal level required to trigger
–60 to 0 dB
panning when SOURCE set to INPUT)
0.1 s–10.0 s The time after which autopan starts once it's been triggered
0.05 Hz–40.00 Hz Autopan speed
Turn L, Turn R Autopan direction
–180 to +180 degrees Pan offset
THRU, 21.2 Hz–8.00
High-pass filter cutoff frequency
kHz
50.0 Hz–16.0 kHz,
Low-pass filter cutoff frequency
THRU
Range Description
0.05–40.00 Hz Modulation speed
0–100% Amplitude modulation depth
0–100% Pitch modulation depth
0.0–400.0 ms Modulation delay time
Sine, Tri Modulation waveform
THRU, 21.2 Hz–8.00
High-pass filter cutoff frequency
kHz
50.0 Hz–16.0 kHz,
Low-pass filter cutoff frequency
THRU
OFF/ON Tempo parameter sync on/off
1
Used in conjunction with TEMPO to determine FREQ.