Hitachi CR22N Instruction Manual page 37

Step Touch panel operation
5
Press the
program No. for which you
created (or
program, and make sure
that the pressed row turns
blue. Then press the RUN
button.
6
NOTE (1) If you make and store changes in a row that already stores run parameters, the previous
parameters are replaced by the new parameters.
(2) You cannot store a run parameter while in running (while the rotor is rotating). Always
perform this function while not in running.
row of the
changed) a
RUN button
Screen displays and notes
2-22
2-3-1 Programmed Operation
The PROGRAM

screen appears.
(If you pressed the
row of the program
No.4, it turned
blue.)
Run screen appears.

Program No.