Hitachi CR22N Instruction Manual page 36

2-3-1 Programmed Operation
Step Touch panel operation
4 Enter run parameters as
follows:
a) Press the area
item which you want to
change.
on-screen keypad, enter
the run parameters (see
section 2-2-1).
Example:
SPEED:7,500 rpm
TIME:HOLD
o
TEMP:25 C
ACCEL:9 / DECEL:9
ROTOR:R22A4
RCF:6420
SAMPLE HEIGHT:0
g.sec:-----
REMARK:hitachi koki
b) After entering the run
parameters,
OK button.
Entering
values
TIME, TEMP, ACCEL,
and DECEL (or DECEL
SLOPE) is necessary.
If you do not enter the
numeric values for them,
The field on which you
do not enter the numeric
value turns red.
If you enter the wrong
numeric values for them,
The field on which you
enter the wrong numeric
value turns red.
of the
Using the
(If you do not enter the numeric value for ACCEL, the following
screen appears.)
press the
the numeric
for SPEED,
Be sure to enter numeric values for SPEED, TIME, TEMP,
￮
ACCEL, and DECEL (or DECEL SLOPE).
（For a programmed operation, it is not necessary to select a
rotor name, and enter remarks, and enter numeric values
for RCF, SAMPLE HEIGHT, and g.sec.）
If you do not enter a numeric value for SPEED, you can not
￮
select ROTOR（）.
If you do not select a rotor name, you can not enter numeric
￮
values for RCF（） and g.sec（）.
Screen displays and notes





2-21
a) The on-screen
keypad appears.
OK button
b) The screen for
displaying the run
parameters appears.
