Maintenance; Backing Up Settings Data - Mitsubishi Electric AE-200A Instruction Book

5. Maintenance

5-1. Backing up settings data

The settings data can be exported to a USB memory as a backup.
Touch [Maintenance] in the menu bar, and then touch [Backup].
Note: Use the USB memory device that meets the requirements described in section 4-1-1 "Energy data output".
Note: IP address settings will not be backed up. Make sure to write them down.
All settings
Important
● The USB memory device may not be recognized if you insert and remove it within a short time. If this happens, reset the
AE-200/AE-50.
● The AE-50/EW-50 data can be output from the AE-200.
(1) Remove the controller cover, and insert a USB memory device to the USB port.
(2) Touch [All settings], then touch [Copy to USB Memory].
The settings data file will be created in the root folder of the USB memory.
■ File output destination, folder name, and file name
[Root folder of the USB memory]\[Serial No.]\"SettingData"\"AE"
*1 "AE1," "AE2," "AE3," or "AE4" when one or more AE-50/EW-50 controllers are connected
<Example>
Root folder of the USB memory
12345-123 (AE-200 serial No.)
Note: It will take a few minutes to create the settings data.
Note: Do not remove the USB memory device while the data is being output.
WT07992X02
SettingData
AE AE-200 settings file
AE1 AE-50_1 settings file
AE2 AE-50_2 settings file
AE3 AE-50_3 settings file
AE4 AE-50_4 settings file
*1
74
Copy to USB Memory
Touch to back up the
settings data.