Connecting Using Wifi Protected Setup (Wps) - Huawei B2368 Series User Manual

LTE CPE B2368 User's
Guide
Basic Service Sets (BSS) at the same time. Each network can assign different priorities to the quality of service
(QoS) and / or security modes.
Wireless devices can then use different BSSID to connect to the same access point (AP).
Note Technology MBSS
•
•
•

5.5.5 Connecting using WiFi Protected Setup (WPS)

This method supports LTE modem WiFi Protected Setup (WPS), which is an easy way to configure a
secure wireless network. WPS specification is an industry standard from the WiFi Alliance.
WPS enables quick setup wireless networks with strong security without the need for manual configuration of
security parameters. Each connection using WPS works between two devices. Both devices must support
WPS (information on compatibility with WPS see instructions on the device).
Depending on the type of devices you can connect WPS start pressing the button (physical button on the
device or software configuration interface), or by entering a PIN (a unique password that one device helps
verify the identity of the other) to both devices. After activating the WPS on one device, it is necessary to be
activated WPS also on the other device, and over the next two minutes. Then there is a connection between
the two devices and create a secure wireless network.
5.5.5.1 Creating a wireless network through the WPS press (PBC)
The way to create a wireless network (sometimes referred to by the acronym PBC) is initiated by pressing the WPS
button on both devices to be connected. Connection then takes place automatically. No further information is required
to enter.
Not all devices support WPS, however, has for this purpose a physical button. WPS button for PBC may be
located, for example, in the configuration interface, as is the case in this instance LTE modem. Connecting via
the WPS button pressing is as follows.
Step 1 Make sure that the two devices together you want to connect, there are close to each other. Step 1 Make sure that the two devices together you want to connect, there are close to each other.
step 2 Find the appropriate WPS button on both devices. If no physical device step 2 Find the appropriate WPS button on both devices. If no physical device
WPS button not sign in to the management interface and search facilities softkey in it (see the manual of the
device, the location of the WPS button, this LTE modem is described in section 5.4 Screen WPS).
step 3 Press on one of the devices (in any order). WPS button of LTE step 3 Press on one of the devices (in any order). WPS button of LTE
a modem is required to press and hold at least 10 seconds.
Issue 01
One access point (AP) allows the establishment of a maximum of eight sub-sets BSS.
Each set of BSS must have its own access key. If two wireless devices using different identifiers (BSSID
= are located in different sets BSS), but the network communication is decrypted with the same key, it is
possible to be able to intercept the second wireless communication device. Mutual communication but
maybe not.
MBSSID not a substitute for 802.1x security standard, but as an option.
Copyright © Huawei Technologies Co., Ltd.
5 Wireless WiFi 2.4 / 5 GHz
49