Huawei B2368 Quick Start Manual

B2368 Quick Start Guide
Part number: 31071064
Issue: 01
Packing List
ttse
,
that
indoor unit (IOU)
Quick Starl Guide
P toparo the following toes
M6 inner hexagon wrench
if you need to install mounVng k!ts on wood matena\s prepare screws (recommended modeli ST 4 2 with length 2 25 mm).
Basic Information
ODU indicators
Steady green LTE signals are strong
The 000
BonRjnq green stamng
Steady blue
LTE sognals are medium.
Steady oranqo LTE are weak.
Blinking orange
There is no LTE Signal or the device
IS searching for LTE signals or
Steady red
STAem eoct (such as PDE barer and key
Stu
moduie
Blinking red The ODU is upgrading.
The LTE device powered off.
IDIJ indicators
o
o
Working Principle and Installation Position
An ODIJ is an LTE wireless signal receiving and transmission unit. You are advised to install ODUs in open areas without obstacles on suitable walls,
balconies, and roofs. You can power on an ODIJ to test signal quality and choose a location with better signal quality for installation.
B2368 ODIJ can be installed at various locations, including planes, slopes, walls, and poles (horizontally or vertically).
havo the tnc pack Ing 'i3t, If Oy
1 x outdoor unit (ODU)
1 x mounting kit
Phillips screwdriver
Adjustable spanner
Steady green The LTE device is running properly.
Blinking green The LTE device is booting up.
Steady red The LTE device detects an error during
self-testing, the device
is faulty, or there is no SIM card.
Blinking red The LTE device IS upgrading firmware.
The LTE device is powered off.
Steady green LTE signals are strong.
LTE signals are medium.
Steady blue
Steady orange LTE signals are weak
There is no LTE signal, or the LTE device is
Blinking orange
receiving power and ready for use.
tie items 's mjss.nq or damaged_ contact your LTE device provider.
O
Cat5e Ethernet cable
For connecting the ODIJ and IDIJ
Cable connections
IDU buttons
Reset buttom
I Press for 3s to IOS to reboot the device.
Press for more than IOS to restore factory settings.
t Reset button RST
WPS button O
WPS button:
t Press for 1 second to enable or disable WI-Fi.
Press for IOS to enable the WPS function.
4 x M6 expanding screw
For mounting on the wall
1 x power adapter
2 x metal belt
For mounting on a pole (048 mm to 9114 mm)
I x Cat5e Ethemet cable
For connecting the IDIJ and PC
Rubber hammer
Optional for mounting on a wall
p R PoE LAN 0-2 TEL
00
PC
o
Power button
WPS
HUAW€I
1 x PG
connector
2 x positioning pi
(one as a spare)
Percussion d/ill
Phone
1