Canon imagePRESS Server F200 Installation And Service Manual page 95

T 2: imagePRESS Server error messages and condition
ABLE
Symptom
1 beep
1 beep, followed by 3
beeps, followed by 3 beeps,
followed by 1 beep
imagePRESS Server does
not start and the control
panel is black.
Activity light status:
Off.
If the Activity light
N :
OTE
is solid orange while the
control panel is black, the
imagePRESS Server is in
Sleep Mode.
T
ROUBLESHOOTING
Possible cause
Beep codes during Startup
No error. The imagePRESS Server
is starting up normally.
Missing, unmatched, incorrect,
or faulty DIMMs
Possibly one of the following:
• The imagePRESS Server is powered off
• Power cable is not plugged into
the power connector on the
imagePRESS Server connector panel,
or into the wall power outlet
• The connector panel power switch is in
the OFF position
• UIB cable is not connected to
the motherboard, the user
interface board, or both
• Faulty power cable
• Faulty power supply (power supply
may not be supplying power to
the motherboard)
• The CMOS jumper is not in the
default position
• Faulty motherboard (motherboard
power plane may not be supplying
power to components)
Suggested action
None
Check for missing, unmatched, incorrect or faulty DIMMs and
reseat the DIMMs to remove any oxidation on the connector
(see page 57).
Startup
1 Recheck all cables and connections.
2 Make sure the connector panel power switch is in the ON
position (see page
3 Listen for the power supply fan and feel for air at the back
of the unit where the power supply is located.
If air is not coming from the power supply fan, isolate a
possible faulty power cable as follows:
• Power on using a different power cable.
• Install a new or "known good" power supply.
4 Check the connector panel fan vent and feel for air coming
out of the back of the system.
If air is coming out of the power supply fan vent but is not
coming out of the connector panel fan vent, the
motherboard may be faulty. You may need to replace
the motherboard (see
5 Review the jumper section on
jumper is in the default position.
33).
page 51).
page 63 and ensure that the
95