Esm Board; Misc Board; Scm Board - Samsung iDCS 500 Technical Manual

iDCS 500 Release 2 / OfficeServ
TECHNICAL MANUAL
• LCP2:
LCP2 Processor Status
OFF indicates that power is OFF
ON indicates that the LCP2 is booting
Flicker indicates normal operation.
• S1~S9
Card Status
OFF indicates that the card is idle or not installed
ON indicates that one or more circuits on the card are in use
Flicker indicates a problem with the card.

3.4 ESM BOARD

This board has no selectable options and installs in position MCP2-D1of the MCP2
card when the system has multiple cabinets
required to expand the system from 512 to 1024 time slots. To install the ESM board
remove the two (2) screws holding the MCP2 protective casing together
7) and separate the two halves of the case. Place the ESM board face down over the
three connectors, taking care to properly line them up and press gently on the back of
the board to seat it. The MCP2 case can now be reassembled if all required daughter
boards have been installed.

3.5 MISC BOARD

This board has no selectable options and installs in position MCP2-D3 of the MCP2
card when the system is running M version software
running L version software the MISC board must be installed in position SCP2-D2 of
the SCP2 card (see Figure 3–3)
boards can be installed in a system (one on the MCP2 or SCP2 and one on each
LCP2). The MISC board is required to provide external music inputs, external page
outputs and programmable relay contacts. To install the MISC board remove the two
(2) screws holding the MCP2 or LCP2 protective casing together
remove the 4 screws holding the SCP2 case together
the two halves of the case. Place the MISC board face down over the two connectors,
taking care to properly line them up and press gently on the back of the board to seat
it. The MCP2/LCP2/SCP2 case can now be reassembled if all required daughter boards
have been installed.

3.6 SCM BOARD

This board has no selectable options and installs in any available position of the MCP2
card when the system is running M version software
running L version software the SCM board may be installed in any available position of
the SCP2 card (see Figure
the MCP2 or SCP2). The SCM board is used to increase the number of available
conference circuits by 18 to 24 and to add 12 DSP circuits for DTMF and tone
(see Figure 3-5)
(see Figure 3-8)
or position LCP2-D2 of the LCP2 cards. Up to 3 MISC
(see Figure 3-10)
3–3). Only one SCM board can be installed in a system (on
3.7
Home Page
PART 3 MARCH 2004
(see Figure 3–6). The ESM board is
(see Figure 3–6). If the system is
(see Figure 3–7)
(see Figure 3–9)
(see Figure 3–2).
Table of Contents
INSTALLATION
(see Figure 3–
or
and separate
If the system is