Samsung iDCS 500 Technical Manual page 41

iDCS 500 Release 2 / OfficeServ
TECHNICAL MANUAL
MGI 2 LED Indication after booting:
RUN
TX
SRV
IPC
3.30 MEDIA GATEWAY INTERFACE 3 (MGI3)
(see Figure 3-- - 23)
The card has eight (8) LEDs on its faceplate to indicate the status of the card. These
indications are described below. Insert the card into any universal card slot.
3–1. Push firmly in the middle of both card ejectors to ensure the card is firmly seated
into the back plane connector.
LED Name
Displays the operational status of the MGI
PWR
card.
RUN Displays the power status.
Displays reception of data through an
RX
Ethernet connection.
Displays transmission of data through an
TX
Ethernet connection.
SRV Displays if card is in service.
ON ON
OFF OFF
ON OFF
OFF OFF
Function
3.18
Home Page
INSTALLATION
PART 3 MARCH 2004
PWR
RX
DSP
MOD
Status
•
Blinking : The MGI card is
operating.
•
Off : The MGI card is not
normally operating
•
On: Power to the MGI
card.
•
Off: No power to the MGI
card
•
Blinking: Data is being
received.
•
Off: Data is not being
received. After initialization
is complete.
•
Blinking: Data is being
transmitted.
•
Off: Data is not being
transmitted.
•
On: Service is available.
•
Blinking: Program is being
modified or configuration
is being downloaded.
•
Off: Service is not
available.
Table of Contents
See figure