Samsung iDCS 500 Technical Manual page 86

iDCS 500 Release 2 / OfficeServ
TECHNICAL MANUAL
6.4 SINGLE LINE TELEPHONES
Using one pair twisted #24 AWG or #26 AWG jumper wire, cross-connect each single
line telephone to the SLI port, 8SLI port, 8MWSLI, 16SLI or 16MWSLI port of your
choice (see Figures 6–3a, 6–3b, 6-3c, 6–3d, and 6–3e)
choice (see part 8 of this installation section).
CAUTION: To reduce the risk of fire, use only No. 26 AWG or larger telecommu-
nication line cord.
Single Line Telephones with message waiting lamps must be connected to the
8MWSLI or 16MWSLI card
6.5 DOOR PHONE AND DOOR LOCK RELEASE
Using one pair twisted #24 AWG or #26 AWG jumper wire, cross-connect each DPIM
to the DLI port (see Figure 6–4a and 6–4b)
Next, connect the DPIM to the door phone using #24 AWG or #26 AWG twisted pair
wire.
CAUTION: To reduce the risk of fire, use only No. 26 AWG or larger telecommu-
nication line cord.
When a customer-provided electric door release is installed, cross-connect the
corresponding door release contacts on the DPIM to the door lock mechanism
Figure 6–4a and 6–4b). Use MMC 501 to program the duration of the contact closure
as required. See the user guides for door lock release
contacts on the DPIM are to be used for low voltage relay control only. The contacts
are rated at 24 VDC–1 amp.
WARNING: Do not attempt to connect commercial AC power to these contacts.
6.6A WALL-MOUNTING KEYSETS
iDCS keysets come equipped with a reversible base wedge. To wall-mount a keyset,
remove the wedge from the keyset and remove the directory tray from the wedge.
Mount the wedge to the wall using one of the methods below
Use screw holes 1 and 2 to attach the base wedge to a standard electrical outlet box.
Use screw holes 1 and 3 to attach to a standard telephone wall-mount plate with
locking pins. This method can cause the keyset to wobble as the keyset feet do not fit
securely to the mounting surface.
(see part 3.16 and part 3.17 of this installation section).
or plug into the KDb-DLI of your choice.
OR
OR
6.2
Home Page
INSTALLATION
PART 6 MARCH 2004
or into the KDb-SLI of your
operation. The door release
(see Figure 6–5).
Table of Contents
(see