Site Requirements - Samsung iDCS 500 Technical Manual

iDCS 500 Release 2 / OfficeServ
TECHNICAL MANUAL
PART 1. SITE REQUIREMENTS
When you are planning the installation of the iDCS 500 Release 2 system, choose a site
that meets the following requirements:
• Select a location for the iDCS 500 system that has enough space for easy
installation and adequate lighting
•
Select a location that will minimize cable lengths.
Table in the iDCS 500 Release 2 General Description Section.
• The equipment should not be exposed to direct sunlight, corrosive fumes, dust,
constant vibration or strong magnetic fields such as those generated by motors and
copy machines.
• A direct commercial AC power outlet is required. Do not use extension cords.
Preferably, a dedicated circuit should be used to minimize the risk of other electrical
equipment being connected that could adversely affect system operation.
• Ensure that all wires and cables going to and coming from the iDCS 500 are
properly routed. Do not cross fluorescent lights or run parallel with AC wires.
• The equipment must be located in an environment that will maintain a temperature
range of 32°–104°F (0°–40°C) and a humidity range of 10%–90% non-condensing.
• This equipment is to be installed only in Restricted Access Areas (Dedicated
Equipment Rooms, Equipment Closets, or the like) in accordance with articles 110-
16, 110-17 and 110-18 of the National Electric Code, ANSI/NFPA 70.
• Allow at least 10" clearance on both sides and 10" clearance on top of the system to
ensure proper ventilation and access to the interior of the cabinet.
• Do not install in close proximity to a fire sprinkler head or to other sources of water.
• Space consideration must be made to allow floor or wall mounting. Do not wall
mount a multiple cabinet system.
Meeting these requirements will help to ensure proper performance and greater life
expectancy of the system.
(see Figure 1–1).
See the Cable Requirements
1.1
Home Page Table of Contents
INSTALLATION
PART 1 MARCH 2004