Samsung iDCS 500 Technical Manual page 113

iDCS 500 Release 2 / OfficeServ
TECHNICAL MANUAL
feet of the KSU. Use the factory-supplied wire harness with 36" white and black leads
to connect batteries (see Figure 7-8).
Observe the following precautions when installing batteries:
a. Make sure the batteries you install conform to local building, fire and safety codes.
Some battery types emit hydrogen gas during the charging state and may require
venting to fresh air.
b. Do not place batteries directly on a concrete floor. This causes them to discharge
very quickly.
c. Follow the battery manufacturer's recommended installation and maintenance
procedures.
7.9 LOUD BELL INTERFACE
When a station requires loud ringing assign or pair that station to an audible ring tone
outputs on one of the three (3) MISC daughterboards using MMC 205.
MISC BOARD
In Cabinet #1
In Cabinet #2
In Cabinet #3
Next connect the output from the MISC card or cards if more than one is required to a
customer provided paging system or other suitable customer provided speaker,
Figure 7.2.
MISC Function
MISC04
MISC04
MISC04
7.4
Home Page
INSTALLATION
PART 7 MARCH 2004
Default DN
3995
3996
3997
Table of Contents
see