Firmware upgrade settings
Firmware upgrade settings
Introduction
With the introduction of PRISMAsync v1.2 for the imagePRESS C800 series, the PRISMAsync
controller software also contains the firmware for the host machine and it's accessories.
By default the firmware supplied with the PRISMAsync software is used for the host machine and
accessories. This guarantees a correct operation of the system.
NOTE
The update at startup is always done incremental.
Automatic firmware check/update by PRISMAsync at startup (default)
The PRISMAsync software contains the compatible firmware for the host machine and
accessories.
By default the PRISMAsync controller checks the firmware installed on the host machine and
accessories after pressing the [Sleep] button on the operator panel at startup. If the installed
firmware differs from the firmware available on the PRISMAsync controller, the firmware will be
upgraded or downgraded with the firmware available on the PRISMAsync controller.
84
Chapter 8 - Firmware upgrades via PRISMAsync