Finish The Installation - Canon imagePRESS C800 Series Technical & Service Manual

Finish the installation

To finish the installation of the PRISMAsync for imagePRESS C800 Series do the following:
Step
1
2
3
4
5
6
7
8
9
Action
Make sure to finish the iPR_C800_Series_Installation_Procedure_for_PRISMA‐
sync.pdf procedure.
Power on the host machine.
Power on the PRISMAsync controller by positioning the On/Off switch at the back-
side of the controller to the On position.
If the PRISMAsync controller does not start automatically, press the On/Off button at
the front side of the PRISMAsync controller.
The startup may take a while, please wait until the user interface displays the splash
screen .
Perform the PRISMAsync installation wizard.
Installation wizard on page
Refer to
If the licences on PRISMAsync controller are not pre-installed, please install them
now.
Installing a license on page
Refer to
Perform any required system software upgrades.
Before updating the PRISMAsync controller, please make sure to create a backup of
the settings.
This backup also contains the licenses installed on your PRISMAsync controller .
Updates for the system software may be available on a FTP server. Patches may
need to be installed after installation. (See
Change the Sleep mode timer (default = 1 minute)
Consult the customer for the new sleep mode setting.
After the software is installed and all settings are made, always make a backup of
these settings.
See: "Service Mode" in
Set the billing counters that have to be displayed on the Operator Panel.
Go to Service Mode. Select: COPIER -> OPTION -> USER 11.
Make the following settings:
• CNT_SW 0
• Counter1 112 Total (Black/Large)
• Counter2 113 Total (Black/Small)
• Counter3 122 Total (Full Color + Single Color/Large)
• Counter4 123 Total (Full Color + Single Color/Small)
• Counter5 102 Total 2
• Counter6 0
• Counter7 0
• Counter8 0
NOTE
Additional toner bottle counters can be displayed. Ask the customer for
preferences.
• Selection of counters via Engine Service mode
• Counters can be retrieved via eRDS/UGW
• Not supported by SNMP
27.
114.
Installing patches on page
Maintenance and Service on page 37
Finish the installation
111)
Chapter 3 - Installation
4
25