Install The Prismasync Supports/Pedestals - Canon imagePRESS C800 Series Technical & Service Manual

Install the PRISMAsync supports/pedestals

NOTE
To reduce the amount of dust that enters the PRISMAsync controller the supports installed on
the controller have to be replaced with the supplied pedestals.
Replace the installed supports
1. Remove the 4 supports installed on the PRISMAsync controller. The removed supports and
screws will not be used.
4x
2. Install the supports delivered with the PRISMAsync controller (4x M3x16 Hex bolt).
4x
Install the PRISMAsync supports/pedestals
Chapter 3 - Installation 19