Canon imagePRESS C800 Series Technical & Service Manual page 110

Re-installation of the system software
NOTE
The "Restore the system settings and licenses" procedure is applicable when:
• The setting "Keep existing jobs and settings after installation" was NOT selected during
creation of the USB stick.
• The HDDs or controller has been replaced.
If you installed the software because the controller was exchanged, you have to re-host the
license. The original license that was stored in the back-up is not valid anymore.
To restore the settings and licenses do the following:
1. Insert the USB stick you used to backup the settings, into the left side of the Operator panel.
2. In the System section of the Maintenance tab on the Operator panel, touch [Go to service
mode].
See also Service mode in
3. In the first screen touch the ´Restore' button. The system will detect the USB stick and will ask
to confirm the location and filename. After confirmation, the settings are copied to the
PRISMAsync.
4. When all the settings are copied, the PRISMAsync will automatically reboot. When ready,
please remove the USB stick. If you were not able to make a backup of the settings before
installation, please use the last backup file you have created.
8. Install patches. (if applicable)
It is possible that there are patches belonging to the new installed system software. Install these
patches now. See next chapter.
9. Create a new backup of settings
Create a backup of the settings and licenses on page 105
See
110 Chapter 9 - System software
Maintenance and Service on page 37.